Hello,
I have made a huge factory to automatize labs, and in doing so have encountered multiple times a bug with U-turn belts.
Since a picture is worth a thousand words, here you go:
As you can see, the U-turn at the top is stuck. The problem is, its totally random. It can work without problem for 30mins, or get stuck after a few minutes only.
Since I used a lot of U-turn in my factory, I was forced to often run all around to gather the materials on the ground and unstuck the belts.
I found a way around by simply making the turns wider, to avoid any possibility of U-turn.
Here another picture of 3 cases where I got the bug, and how I have fixed it:
[Resolved 0.2.8] U-turn belts randomly getting stuck
Re: [Bug]U-turn belts randomly getting stuck
Hi, thanks for your detailed report.
Could you try if this is still happening in 0.2.7?
If so, could you provide me some save with stucked situation, so I could inspect it more precisely?
Could you try if this is still happening in 0.2.7?
If so, could you provide me some save with stucked situation, so I could inspect it more precisely?
Re: [Bug]U-turn belts randomly getting stuck
Yup, still happening in 0.2.7.
I was lucky and managed to reproduce it a few seconds after remaking a u-turn on a fast belt.
Here's the save: http://www.mediafire.com/?6aa2aek9oia9amq
I was lucky and managed to reproduce it a few seconds after remaking a u-turn on a fast belt.
Here's the save: http://www.mediafire.com/?6aa2aek9oia9amq
Re: [Resolved 0.2.8] U-turn belts randomly getting stuck
This should be resolved in the upcoming 0.2.8 release.