Factorio Forums

Because of the yellow lines of roboports. Sometimes its hard to see what to remove.
WIth roboport placements i fast remove yellow lines to hover my roboport over my Hotbar.
This also works with blueprints.

WIth Deconstrucion planner tool, you need to place it back in hotbar. release it, then yellow lines disappear, then take back the item again. to remove something.

Think this item should work the same way as blueprints and roboports.

--- visualisaion ---

desonstruction planner vs

blueprint (same behavor as roboport)
when not hovering withblue print on hotbar

While working on the "Twinsen Hero bug". Someone changed the title of this bug report...

With the same item, while removing lots of forest with a selection to drag, you some times accidently hover over your hotbar/belt or most right 8 weopon slot. This couses the selection to disapear, and do the selection again. (not clicking, if you would click on the hotbar i assume the selection would be gone, but thats not the case)

So these are 2 twinsens for 1 item?

rorror wrote:While working on the "Twinsen Hero bug". Someone changed the title of this bug report...

Huh? The changed title usually means that the bug has been assigned to a dev. In this case to me.
I will start looking at both of the issues.

Well i never knew that fact

Tought it was called a Twinsen bug, (Twinsen the Advangures, that overcomes problems, and solves them on his travels. Wiki?)
Well anyway, thanks for working on this case! And my appolgies for the confusion.

Did the following minor changes based on your posts:
- When using the deconstruction planner, the logistic network is not drawn if the mouse if over a GUI element
- Blueprint, deconstruction and cancel deconstruction selection boxes will not get un-selected when hovering over GUI elements, but they will not activate if the mouse is released under a GUI element.

You will see these modifications in the next release.
Thanks.

Robert, Tnx for all the adjustments. I really appriciate the effort!