Page 1 of 1
how do I set the traffic lights so that this train passes?
Posted: Mon Feb 05, 2024 7:16 pm
by Pewdiefly
how do I set the traffic lights so that this train passes?
Re: how do I set the traffic lights so that this train passes?
Posted: Mon Feb 05, 2024 7:31 pm
by Loewchen
The way you did it on the horizontal track already, the entrance gets the chain signal, the exit the regular one.
Re: how do I set the traffic lights so that this train passes?
Posted: Tue Feb 06, 2024 1:28 am
by Trific
Keep in mind that trains follow the signals on their right side.
Re: how do I set the traffic lights so that this train passes?
Posted: Tue Feb 06, 2024 5:34 am
by Nosferatu
When you fix what was said above the train should no longer enter the crossing it can't leave.
But the next sector is not free yet.
The problem is not this crossing but the V crossing ahead.
You haven't placed any signals there yet correct?
Re: how do I set the traffic lights so that this train passes?
Posted: Sun Feb 18, 2024 10:48 pm
by TBC_x
My general guideline is - Put chain signals everywhere for any single-track system. Then you can tinker with regular signals later to figure out how to use them.